HYDRAULIC CHUCKS
HYDRAULIC CHUCK LATHE TYPE — R TYPE CLAMPING RANGE: ø3-10mm Unique block design enables easy handling for both upper or lower tool post position. Oil hole drills can be used for coolant delivery with M6.
H
E
12.5mm
ø4.5mm (x2)
M6
L 1
12.5mm
25mm
L
W 1
W 2
Catalog Number
ød
øD
L
L 1
W 1
W 2
H
E
SL22R-HDC3-40* SL22R-HDC4-40 SL22R-HDC6-40 SL22R-HDC8-40 SL22R-HDC10-40
3mm 4mm 6mm 8mm
.28 .35 .20
1.38 1.65 2.17
.63 .75 1.0 1.2 1.3
.551
.65
1.57
.65
.709 .787 .866
.24
.69
2.13
10mm
*Some coolant comes out from the inner slots in the coolant-through application • Adjusting screw cannot be used • “E” is the min. clamping length
Use only cutting tools that have a shank tolerance of h6 (see table pg. 26). Do not use with cutting tools made with a flat on the shank (ie: Weldon type shank). Roughing end mills are not recommended for use with hydraulic chucks. Do not tighten the clamping screw without first inserting a cutting tool into the tool holder. Always insert the cutting tool into the hydraulic tool holder beyond min. clamping length “E”. ! CAUTION
ACCESSORIES
GRIP BAR PG. 397
R Type • Unique design for use with both upper and lower sections without interference • Tightening at an offset position in the tool side • Coolant delivery with M6 is possible when mounted on the upper section
313
Powered by FlippingBook