HYDRAULIC CHUCK
JET COOLANT TYPE CLAMPING RANGE: ø4-32mm Coolant Holes Through Body of Holder
COOLANT
JET THROUGH
THROUGH
H
H
Coolant Pipe (Optional)
Coolant Pipe (Optional)
Min Clamping Length E
Min Clamping Length E
Manual Clamping Hole
Manual Clamping Hole
L 1
L 1
L
L
Fig. 1
Fig. 2
Catalog Number
Weight (lbs.)
Fig.
ød
øD
øD 1
øD 2
L
L 1
H
E
HSK-A63-HDC4J-75
4mm 6mm 8mm
.91
2.95
1.14
2.09 3.86 3.74 3.70 3.66 3.62 6.58
.75 .98
2.2 2.6 2.6 2.9 2.9 3.3 3.3 4.6 5.1
.787
-HDC6J-120 -HDC8J-120 -HDC10J-120 -HDC12J-120 -HDC16J-120 -HDC20J-120 -HDC25J-120 -HDC32J-120
1.10 1.18 1.26 1.34
.866 .945
1.18 1.26 1.38
2.76
10mm 12mm 16mm 20mm 25mm 32mm
1
1.89
1.024 1.339 1.496 2.008 2.362
4.72
1.69
2.99
1.65
2.48 2.72
2.24
1.97 2.09
1.93 2.20
2
3.66
—
• Coolant Pipe must be ordered separately • Adjusting screws cannot be used
Use only cutting tools that have a shank tolerance of h6. Do not use with cutting tools made with a flat on the shank (ie: Weldon type shank). Roughing end mills are not recommended for use with Hydraulic Chucks. Do not tighten the clamping screw without first inserting a cutting tool into the tool holder. Always insert the cutting tool into the hydraulic tool holder beyond min. clamping length “E”. ! CAUTION
185
Powered by FlippingBook