HYDRAULIC CHUCKS
JET COOLANT TYPE CLAMPING RANGE: Ø4mm-12mm Coolant Holes Through Body of Holder
COOLANT
JET THROUGH
THROUGH
H
E
L 1
L
Catalog Number
Min Clamping Length E
Weight (lbs.)
Ød
ØD
ØD 1
ØD 2
L
L 1
H
C5-HDC4J-90 C5-HDC6J-90 C5-HDC8J-90 C5-HDC10J-90 C5-HDC12J-90 C6-HDC4J-90 C6-HDC6J-90 C6-HDC6J-120 C6-HDC8J-90 C6-HDC8J-120 C6-HDC10J-90 C6-HDC10J-120 C6-HDC12J-90 C6-HDC12J-120
4mm 6mm 8mm
.75 .98
1.6 1.6 1.6 1.7 1.7 2.4 2.4 2.9 2.4 2.9 2.4 2.9 2.6 2.9
.787
1.02
2.01
1.65
.866 .945 1.02
1.10 1.18 1.26
3.54
1.22 1.30 1.42
3.27
10mm 12mm
1.73 1.81
2.05
4mm
.75
1.02
3.54
1.85
3.19
.787
6mm
.98
4.72 3.54 4.72 3.54 4.72 3.54 4.72
2.91 1.89 2.95 1.89 2.95 1.93 2.99
4.37 3.19 4.37 3.19 4.37 3.19 4.37
1.10
8mm
.866
1.22
1.89
1.18
10mm
.945
1.30
1.26
12mm
1.02
1.42
1.34
• Adjusting screws cannot be used
Use only cutting tools that have a shank tolerance of h6 (see table pg. 26). Do not use with cutting tools made with a flat on the shank (ie: Weldon type shank). Roughing end mills are not recommended for use with hydraulic chucks. Do not tighten the clamping screw without first inserting a cutting tool into the tool holder. Always insert the cutting tool into the hydraulic tool holder beyond min. clamping length “E”. ! CAUTION
257
Powered by FlippingBook