LARGE DIAMETER BORING HEADS
FINE BORING COMPONENT SELECTION The table below determines the components such as extension slide (1), boring head (2), insert holder (3) and counter weight (4) for each diameter range and shows in which position the boring head and the counter weight have to be mounted on the extension slide. Balancing of the tool combination takes place by adjusting the slide (5) on the counter weight according to the scale. The correction value ( α ) is shown on the table. See example below.
ØD (Pos. 1)
1 2 3 4 5
1 2 3 4 5
ØD (Pos. 2)
1 2 3 4 5
1 2 3 4 5
CKB7
CKB6
Balance Factor
Extension Slides
Boring Head
Insert Holders
Counterweights 12345 12345 12345 12345
ØD
Position
7.795-9.331 9.173-10.709 10.551-12.087 11.929-13.465 13.307-14.843 14.685-16.220 16.063-17.598 17.441-18.976 18.819-20.354 20.197-21.732 21.575-23.110 22.953-24.488
1 2 1 2 1 2 1 2 1 2 1 2
7.874 9.252
10.318.222 10.318.205*
10.630 12.008 13.386 14.764 16.142 17.520 18.898 20.276 21.654 23.031
10.318.223 10.318.206*
10.318.224
10.626.271 (TC11) or 10.626.371 (CC09)
10.318.111 (see also pg. 501)
10.318.107 (Fixed) 10.318.115 (Inch)
10.318.225
10.318.226
10.318.227
*For use with ISO40 and HSK-A63 tapers
Example: Diameter Setting According to Scale
ØD: 18.880 Extension Slide: 10.318.223
Position: 1 Correction Value α : 10.630
Scale Value: ØD- α =10.880-10.630=.250
503
Powered by FlippingBook