Catalog Number
H Max
Max RPM
Weight (lbs.)
ØD 2
L
L 1
L 2
E
Fig.
Ød
ØD
ØD 1
4mm 6mm 8mm
HSK-A100-HDC4S-150 HSK-A100-HDC6S-150 HSK-A100-HDC8S-150 HSK-A100-HDC10S-150 HSK-A100-HDC12S-150
.75 .98
20,000 20,000 20,000 20,000 20,000
5.6 5.6 6.2 6.2 6.4
.551
2.05
1.02
2.25
4.76
5.910
3.54
2
.669 .748 .827
2.13 2.20 2.28
1.10 1.18 1.26
1.22 1.30 1.42
10mm 12mm
2.05
4.53
• Coolant pipe must be ordered separately • Adjusting screws cannot be used • Some coolant may leak from the inner diameter slits when center through coolant is used with models marked
Use only cutting tools that have a shank tolerance of h6 (see table pg. 26). Do not use with cutting tools made with a flat on the shank (ie: Weldon type shank). Roughing end mills are not recommended for use with hydraulic chucks. Do not tighten the clamping screw without first inserting a cutting tool into the tool holder. Always insert the cutting tool into the hydraulic tool holder beyond min. clamping length “E”. ! CAUTION
ACCESSORIES
GRIP BAR PG. 407
201
Powered by FlippingBook