HYDRAULIC CHUCKS
SUPER SLIM TYPE CLAMPING RANGE: Ø4-12mm
COOLANT
THROUGH
H Max
Min Clamping Length E
L 1
L
Catalog Number
Weight (lbs.)
Ød
ØD
ØD 1
L
L 1
E
H Max
3mm 4mm 6mm 8mm
C4-HDC3S-55 C4-HDC4S-75 C4-HDC6S-75 C4-HDC8S-75 C4-HDC10S-75 C4-HDC12S-75
.709
2.17
.67
.630 .748 .984
1.929
.8 .9 .9
.551
.906
1.50
2.95
2.717
.670 .748 .827
1.02 1.10 1.18
1.220 1.299 1.417
1.0 1.0 1.0
10mm 12mm
1.54
• Adjusting screws cannot be used • Some coolant may leak from the inner diameter slits when center through coolant is used with models marked
Use only cutting tools that have a shank tolerance of h6 (see table pg. 26). Do not use with cutting tools made with a flat on the shank (ie: Weldon type shank). Roughing end mills are not recommended for use with hydraulic chucks. Do not tighten the clamping screw without first inserting a cutting tool into the tool holder. Always insert the cutting tool into the hydraulic tool holder beyond min. clamping length “E”. ! CAUTION
ACCESSORIES
GRIP BAR PG. 407
265
Powered by FlippingBook