C-CUTTER MINI OVERVIEW
ULTRA HIGH FEED CHAMFER MILL Compact design with 4 inserts & small cutting diameter. High performance chamfer cutter achieves ultra high feed rate by reducing the cutting diameter to the lowest limit.
Tap Hole Chamfering
Counter Bore Chamfering
Back Chamfering Face Milling Chamfering
Chamfering
A VARIETY OF INTERFACES AVAILABLE
FOUR INSERTS, SMALL DIAMETER AND NEW COATING ACHIEVE A TRIPLE EFFECT
EFFECT 1 — Maverick Design with Ultra High Feed by 4 Inserts Compared with 1 or 2 inserts per cutter, a 4 insert cutter multiplies the feed rate. EFFECT 2 — Increased Spindle Speed by Ultra Compact Diameter A smaller tool diameter means faster spindle speeds. EFFECT 3 — Latest Coatings [ACP200/300] Increases the Cutting Speed Wear resistant multi-layer PVD coating increases the cutting speed.
C-CUTTER MINI
Competitor's Cutter
Considerably Improved!
No. of Teeth
Spindle Speed
Feed Per Tooth
Feed Rate =
Cutting Speed x Cutting Diameter
Spindle Speed
Small cutting diameter and 4 inserts.
Large cutting diameter with only 1 or 2 inserts.
Small dia.
General Products
C-CUTTER MINI (ST12-C116-45B-25)
GREATER CUTTING EFFICIENCY 8 TIMES
Small Diameter
Chamfering diameter Number of inserts Cutting speed Vc (m/min) Spindle speed n (min-1)
ø29
ø13.5
Inscribed Circle Ø.130
Cutting Conditions Workpiece: S55C Chamfering Amount: C1 Feed Per Tooth fz: .1mm/t
2
4
UP UP
150
300
HEX INSERT Highly-efficient back chamfering from 5mm starting hole diameter.
7,040
1,646
UP
Feed Vf (mm/min)
Much Higher!
2,820
329
50
Powered by FlippingBook