GROOVE MILLING TOOLS
BLANK INSERTS Periphery ground without rake angle and chip breakers.
Catalog Number
Catalog Number
Catalog Number
Type 0
Grade
Type 1
Grade
Type 2
Grade
E Max .157 B Max .039
E Max .157 B Max .075
E Max .236 B Max .098
10.958.313
10.958.157
10.958.155
C3
C3
C3
Ø.453
B
B
B
10.958.314
10.958.158
10.958.156
C5
C5
C5
TECHNICAL INFORMATION: In all circular milling operations the programmed feed rate S applies to the center of the milling cutter. This may be computed as follows: D-d S = S1 x D Where: S = Feed rate for cutter center to be programmed in in/min S1 = Circumferential feed in in/min from table D = Bore diameter
Ød
SPEEDS & FEEDS
Slot Cutter Center
Cutter Speed & Feed Steel: 328 SFM Cast Iron: 427 SFM Alum.: 591 SFM
Cutter Dia.
Speed
1500 RPM 11.8 IPM 1000 RPM 11.8 IPM 650 RPM 10.2 IPM 380 RPM
2000 RPM 15.7 IPM 1300 RPM 15.4 IPM 850 RPM 13.4 IPM 500 RPM 11.8 IPM
2700 RPM 21.3 IPM 1800 RPM 21.3 IPM 1200 RPM 18.9 IPM 700 RPM 16.5 IPM
.827
S1
Speed
ØD
1.299
S1
Speed
1.890
S1
These values relate to the milling cutter circumference and apply under normal working conditions. Climb-cut milling is recommended with helical or tangential plunging to groove depth assuming a continuous program cycle without feed interruption.
Speed
3.268
S1
9.0 IPM
637
Powered by FlippingBook