BIG DAISHOWA High Performance Tooling Solutions Vol 3

CLEANERS

Ø160 STEEL SHANK TYPE

Catalog Number

ST20S-CBL160

500 rpm (.5 sec)

1,000 rpm

2,000 rpm

Startup Spindle Speed*

(.5 sec)

Min. 6,000 Max. 9,000 rpm

Recommended Spindle Speed

Rotation Direction

Forward

Flange: Ø2.60

Distance to the Workpiece Surface to be Cleaned (with wing opened to maximum)

3.94"-5.91"

Recommended Movement Feed

118-394 ipm

*The wing may open during ATC when it is used with an ultra-high speed ATC machining center

Ø260 & Ø330 STEEL SHANK TYPE

Catalog Number

ST20S-CBL260 ST20S-CBL330

1,000 rpm

2,000 rpm

500 rpm (.5 sec)

Startup Spindle Speed*

(.5 sec)

Min. 4,000 Max. 7,000 rpm

Min. 3,000 Max. 6,000 rpm

Recommended Spindle Speed

Rotation Direction

Forward

Distance to the Workpiece Surface to be Cleaned (with wing opened to maximum)

3.94"-5.91"

Flange: Ø2.60

Recommended Movement Feed

118-394 ipm

*The wing may open during ATC when it is used with an ultra-high speed ATC machining center

! CAUTION

• Startup Spindle Speed — In newer high-speed machining centers, the machine spindle rotation rise has become faster. A sudden command for spindle speed may create a strong impact on the wing as it opens; therefore, be sure to rotate it at the startup speed in the table above before raising it to the designated spindle speed. • The spindle speed and the distance to the workpiece surface in the above table differ depending on the weight of the cutting chips. Be sure to confirm before use.

• The wing may open during ATC when it is used with an ultra-high speed ATC machining center. • When supplying coolant with center through, be sure to stop the spindle rotation first. • This product must be used only with a machine with a full cover. • Never modify this product in any way.

• Although the wing is made of high-strength carbon fiber reinforced resin, it may be worn out or damaged due to the collision of cutting chips or impact when opening/closing. If wear and damage progress, the wing may snap and fly out during use. Be sure to periodically check the damage of the wing visually and replace it as needed. • The cylindrical shank outer diameter of the chip blower is Ø20. Use a BIG NEW BABY CHUCK for the holder. Grasping with a holder with low inner diameter collapsibility is dangerous and must be avoided.

671