HYDRAULIC CHUCK LATHE TYPE — R TYPE CLAMPING RANGE: ø3-10mm Unique block design enables easy handling for both upper or lower tool post position. Oil hole drills can be used for coolant delivery with M6.
.28 .35 .20
1.38 1.65 2.17
.63 .75 1.0 1.2 1.3
.75 .73 .79 .79 .77
-HDC4-40 -HDC6-40 -HDC8 -40 -HDC10-40
6mm .709 8mm .787 10mm .866
*Some coolant comes out from the inner slots in the coolant-through application • Adjusting screw cannot be used • “E” is the min. clamping length
R TYPE •Unique design for use with both upper and lower sections without interference. •Tightening at an offset position in the tool side. •Coolant delivery with M6 is possible when mounted on the upper section.
Use only cutting tools that have a shank tolerance of h6. Do not use with cutting tools made with a flat on the shank (ie: Weldon type shank). Do not tighten the clamping screw without first inserting a cutting tool into the tool holder. Always insert the cutting tool into the hydraulic tool holder beyond min. clamping length “E.” ! CAUTION
2600 Huntington Blvd | Hoffman Estates, IL 60192 | P: (224) 770-2999 | F: (224) 770-2997 | firstname.lastname@example.org | www.bigdaishowa.com
Powered by FlippingBook