HYDRAULIC CHUCKS
HYDRAULIC CHUCK (SUPER SLIM TYPE) CLAMPING RANGE: ø4-12mm
COOLANT
THROUGH
H Max
Min Clamping Length E
L 1
L
Catalog Number
Weight (lbs.)
ød
øD
øD 1
L
L 1
E
H Max
C4-HDC3S-55 C4-HDC4S-75 C4-HDC6S-75 C4-HDC8S-75 C4-HDC10S-75 C4-HDC12S-75
3mm 4mm 6mm 8mm
.709
2.17
.67
.630 .748 .984
1.929
.8 .9 .9
.551
.906
1.50
2.95
2.717
.670 .748 .827
1.02 1.10 1.18
1.220 1.299 1.417
1.0 1.0 1.0
1.54
10mm 12mm
• Adjusting screws cannot be used • Some coolant may leak from the inner diameter slits when center-through coolant is used with models marked
Use only cutting tools that have a shank tolerance of h6 (see table pg. 26). Do not use with cutting tools made with a flat on the shank (ie: Weldon type shank). Roughing end mills are not recommended for use with hydraulic chucks. Do not tighten the clamping screw without first inserting a cutting tool into the tool holder. Always insert the cutting tool into the hydraulic tool holder beyond min. clamping length “E”. ! CAUTION
ACCESSORIES
GRIP BAR PG. 393
267
Powered by FlippingBook