HYDRAULIC CHUCKS
Catalog Number
Weight (lbs)
A
B
W H
E
Fig.
ød
øD
øDs
L
L 1
SL25.4F-HDC3-105 SL25.4F-HDC4-105 SL25.4F-HDC6-100 SL25.4F-HDC8-95 SL25.4F-HDC10-90 SL25.4F-HDC12-85
3mm 4mm 6mm
.63 .75 .98
1.13
.28
3.03
.79
.511
3.94 3.74 3.54 3.35
2.83 2.64 2.44 2.20
.75 .66 .60 .53
2
1.000
.12
— — —
8mm .669
1.22 1.30 1.42
10mm 12mm
—
—
• Adjusting screw cannot be used • “E” is the min. clamping length • Some coolant may leak from the inner diameter slits when center-through coolant is used with models marked
Use only cutting tools that have a shank tolerance of h6 (see table pg. 26). Do not use with cutting tools made with a flat on the shank (ie: Weldon type shank). Roughing end mills are not recommended for use with hydraulic chucks. Do not tighten the clamping screw without first inserting a cutting tool into the tool holder. Always insert the cutting tool into the hydraulic tool holder beyond min. clamping length “E”. ! CAUTION
ACCESSORIES
GRIP BAR PG. 393
F Type • Tighten from the opposite side of the tool • Coolant delivery is possible with Rc(PT)1/8 screw • Optimum overall length for easy use • Ideal for use on a front tool post
303
Powered by FlippingBook