CHAMFER MILLS
C-CENTERING CUTTER (3 INSERT)
4.92
35mm
45º
H Min
Catalog Number
øDc
øC Min
øC Max
H Min
Insert
ST32-CN1433-45-125
1.339
.551
1.299
.024
CN0906
• Wrench and screw is included; inserts must be ordered separately • Centering is not possible
INSERTS
Insert Grade
Screw Set Catalog Number
Catalog Number
øD
ACM250F (For Steel/Cast Iron/Stainless Steel)
DS20 (For Aluminum)
ACZ150 (For Steel/Cast Iron/Stainless Steel)
CN0906 S4S-15IP • Inserts are available in a packet of 10 pcs.; please specify the insert model number and grade when ordering Example: CN0906 ACM250F.........10 pcs. • The insert clamping screw set contains 10 screws and 1 wrench • Insert clamping screws and tightening wrench are consumables; order periodically for replacement or spares. .375 z z z
Cutting Conditions
• The table is just a reference to determine cutting conditions, it should be adjusted according to the condition of the machine tool and workpiece • Be sure to use water-soluble cutting fluid during spot drilling • For traverse chamfering, dry cutting (including air blowing) is recommended; however, if severe built-up edge occurs in aluminum machining, use water-soluble cutting fluid
Feed (IPT) Spot Drilling Traverse Chamfering
Cutting Speed Vc (SFM)
Workpiece Material
Carbon Steel, Alloy Steel
165-500 165-400 230-650 330-1000
.001-.003 .001-.002
Stainless Steel
.002-.008
Cast Iron
.001-.003
Aluminium, Non-ferrous Metals
546
Powered by FlippingBook